Weekly PSA: Don't buy the AMS Hub save yourself money! : …

Jul 7, 2024 · Weekly PSA: Don't buy the AMS Hub save yourself money! Discussion (self.BambuLab) ... I followed this advice earlier this week and printed out my ams stacker with …

CouponFollow Extension

3%
OFF

Bambu Team, I Would Gladly Pay For An Upgrade Parts Path For An …

1 week from now

Jun 23, 2023 · Correct, this is not the place to get in contact with Bambu Labs regarding AMS improvements that .3% would benefit from and from the small percentage of gain for this …

redditmedia.com

$399
OFF

The Bambu A1 - Do I Regret Buying An A1 Mini A Month Ago?

1 week from now

Conclusion. Both the Bambu A1 and A1 Mini are fantastic printers that are priced quite aggressively. At $399, you can buy two Bambu A1 printers that are bigger, faster, and more …

patshead.com

$50
OFF

Aw Shucks. Just Thought I’d Save Bambu Some Tickets By ... - Reddit

1 week from now

Each hub is $50. You'd would need 5 hubs to do 16 colors with AMS lite. So that's $250. So you'd save $200 to go with 4 AMS lites + 5 hubs vs the 4 AMS + 1 hub. The four AMS lite's would …

reddit.com

FAQs about Weekly PSA: Don't buy the AMS Hub save yourself money! : … Coupon?

Do I need AMS hub?

Can Ams filament feed without a hub?

You may have a problem with filament feeding without the hub - specifically that little spring in the hub is there to give slack to the filament and allow constant feeding into the extruder. It “loads” when the AMS releases some filament which then gets used in the extruder and repeat. Not sure how well this will work without the hub. ...

What is the AMS hub?

Shipping rates vary by locations. See our Shipping Policy for details. The AMS Hub is used to expand the number of AMS connected to Bambu X1/P1 series printers from 1 AMS unit (4 channels) to a maximum of 4 AMS units (16 channels) to improve the refueling speed across your multiple AMS units and support the redundancy of a buffered signal. ...

How do I connect my AMS hub to my printer?

Install the AMS Hub on the back of the printer, replacing the Filament buffer if you have one, and use the matching Bambu 4 Pin cable to connect to the printer, use the Bambu 6 Pin cable to connect to the first AMS, then continue to use the 6-pin cable to connect the remaining AMS in series. ...

Can I use a Bambu AMS Lite 4-1 splitter adapter instead of AMS hub?

AMS Lite 4-1 Splitter adapter to use buffer instead of AMS hub. After discovering that I could use a Bambu AMS buffer along with a splitter instead of having to buy the AMS hub, I found I wasn't happy with the quality of 4-1 splitters I was printing myself. ...

Why is my AMS printer not recognizing the power cables?

And since the power cables to the AMS units are daisy chained, they are all recognized by the printer. You may have a problem with filament feeding without the hub - specifically that little spring in the hub is there to give slack to the filament and allow constant feeding into the extruder. ...